What you need
- A ruler or tape measure (or a sheet of paper with two marks)
- Your cm/360 – the calculator above shows it for your game, sensitivity and DPI
- A place in the game where you can turn freely, ideally a practice range
The 360° test step by step
- Calculate your cm/360 with the calculator above.
- Mark the start and end on your mousepad: place the ruler next to the mouse and note where the edge of the mouse starts and where it should end after exactly your cm/360.
- Aim at a clear point in the game, such as the corner of a wall.
- Move the mouse slowly and steadily along the ruler until the edge reaches your end mark. Do not lift it.
- Check your crosshair. If you are back on the same point, your sensitivity matches the calculation.
If your cm/360 is longer than your mousepad, test a 180° turn instead: move half the distance and you should be looking in exactly the opposite direction.
What the result tells you
- Exactly on target – everything is set up correctly.
- Always slightly off in the same direction – check that the DPI in your mouse software matches the DPI you entered, and that you typed the sensitivity correctly. Some games also round the value you enter.
- Different result when you move fast vs. slow – that is mouse acceleration. See how to turn off mouse acceleration.
Repeat it in every game
Do the same test after converting to a new game. If both games turn exactly 360° over the same distance, they will feel identical – that is the whole idea of converting your sensitivity.